12V 2.4G RX19 4x4 4WD Control Box Receiver for Kids

12V 2.4G Mainboard RX19 4x4 Four-Wheel Drive Control Box Receiver

This 12V 2.4G mainboard with the RX19 model number is one of the ride on car electrical parts Magic Cars offers for children's battery-powered ride-on vehicles. It works as a replacement control box receiver for the four-wheel-drive (4x4, 4WD) 12-volt motherboard.

Check Fit Before You Buy

• Open your ride-on car and locate the existing control box.
• Compare its appearance with the photos and details shown here.
• If the layout matches, this part should fit your car.
• Confirm that your original mainboard is consistent with this one before ordering.

Key Features

• 12V 4x4 four-wheel-drive motherboard
• 2.4G wireless receiver that matches the Wireless Magic Cars Parental Control, where applicable
• Slow start and slow acceleration for young riders
• Designed for kids' powered ride-on cars

Pairing the Remote (First Use or After Battery Replacement)

The receiver must be matched to the remote the first time it is used, and again after the remote batteries are replaced.

1. Install the batteries: Insert two AAA 1.5V batteries, observing the positive and negative polarity inside the battery chamber. Close the cover. The indicator will flash three times, which shows the batteries are installed correctly.
2. Enter pairing mode: Press and hold the frequency key (car select) for about 2 seconds until the indicator flashes.
3. Power the car: Turn on the car's power. The indicator will turn off when pairing succeeds.
4. Retry if needed: If the indicator stays on, turn off the power and repeat steps 2 and 3.

Important Note

Before purchasing, make sure your original mainboard matches this product. Fitment depends on the control box layout of your specific electric ride-on car.

Specifications

• Weight: 0.31 Pounds
• Material: Plastic

Shop all Magic Cars® ride on cars →